GideonTech.com Forums

  • October 02, 2022, 11:18:42 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Pages: [1]   Go Down

Author Topic: stepper motor torque  (Read 5775 times)

JoeJoe

  • Senior Modder
  • ***
  • Karma: +2/-0
  • Offline Offline
  • Posts: 297
stepper motor torque
« on: February 26, 2009, 12:46:02 AM »

hello all, just a question on increasing the torque from my stepper motor. i built a controller using this schematic:


i am using an old computer power supply to power the motors (rated at 12vdc 75 ohm's). i know you can increase the torque by increasing the voltage, but you have to limit the current but i have no idea how to do that. to give a baseline, lets say i wanted to triple the voltage to 36v, what would the schematic be for the current regulation?
Logged

doump

  • Case Mod Weenie
  • *
  • Karma: +0/-0
  • Offline Offline
  • Posts: 2
    • hi!
-
« Reply #1 on: June 27, 2022, 06:22:13 AM »

I found this formula for motor timing that seams correct but I cant verify it. Anyone see this before:

180 degrees / pole count = motor timing with maximum torque
Logged
Pages: [1]   Go Up
 

Page created in 0.084 seconds with 33 queries.