Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Spydog101]

I have been watercooling my pc for about two years now and just finished working on a new case and want to carry my system over to the new case.  When I first started I used 3/8 tubing, but was think about changing it to 1/2.  My blocks, res, and pump, I can get w/ 1/2 fittings, but my rad. only comes w/ 3/8 (black ice micro II).  Do you think it would still be a good idea to go w/ 1/2 even though the rad will be 3/8?  It is also time to replace my pump, so I figured this would be the best time see about the tubing size.  My other question is, does anyone know where I can find some 270 degree elbows in 3/8 or 1/2 preferably not in brass?  Thx for the help.  

[Archaon]

Buy flexible tubing...?

[KoRn Addict]

just to let u know, a 270* elbow is no different than a 90* elbow

[ClearCaseMan]

just to let u know, a 270* elbow is no different than a 90* elbow

hahaha.
But I dont want the 90's I want a 270

[blafrisch]

just to let u know, a 270* elbow is no different than a 90* elbow

hahaha.
But I dont want the 90's I want a 270

Buy a 90, turn around.  Then you are set.

I'd look in a hardware store in plumbing or there is an off chance that they'd have it in electrical (very off chance).  I know most are brass, but they do carry some in chromed steel.

[ClearCaseMan]

try a hydrilics shop they often have many types of fittings. we have a shop here called fluidair of columbia that carries dozens of types of fittings

[Spydog101]

my bad, I ment 110 degree elbow.  I dont know how I messed that one up.