GideonTech.com Forums

  • October 17, 2019, 07:41:13 AM
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Pages: [1]   Go Down

Author Topic: Led question  (Read 1112 times)

gilgamesh

  • GT Fanatic
  • **
  • Karma: +0/-0
  • Offline Offline
  • Posts: 144
Led question
« on: September 13, 2003, 09:07:07 AM »

I haven't done much iring at all... This may seem like a stupid question but,

how many volts are the power and hdd led connectors?

probably need a resistor anyways...
Logged

Fump

  • GT Fanatic
  • **
  • Karma: +0/-0
  • Offline Offline
  • Posts: 50
Led question
« Reply #1 on: September 13, 2003, 09:30:47 AM »

the voltage is enough to run a led straight off it, so about 2.5V or somthing like that. if you are goin 2 replace the leds on the power and HDD then you can jus swap them for what u want (5V or 12V leds wont work as well as the lower voltage 1's.) hope that helps.
Logged
Pages: [1]   Go Up
 

Page created in 4.983 seconds with 33 queries.